Dmx Addressing - ADJ 32 HEX PANEL IP User Instructions

32 Hex Panel IP/32 Hex Panel IP Pearl
All fixtures should be given a DMX starting address when using a DMX controller, so the correct fixture
responds to the correct control signal. This digital starting address is the channel number from which
the fixture starts to "listen" to the digital control signal sent out from the DMX controller. The assignment
of this starting DMX address is achieved by setting the correct DMX address on the digital control
display on the fixture.
You can set the same starting address for all fixtures or a group of fixtures, or set different addresses
for each individual fixture. Setting all fixtures to the same DMX address will cause all fixtures to react
in the same way, in other words, changing the settings of one channel will affect all the fixtures
simultaneously.
If you set each fixture to a different DMX address, each unit will start to "listen" to the channel number
you have set, based on the quantity of DMX channels of each fixture. That means changing the settings
of one channel will only affect the selected fixture.
In the case of the 32 Hex Panel IP/32 Hex Panel IP Pearl, when in 6 channel mode you should set the
starting DMX address of the first unit to 1, the second unit to 7 (6 + 1), the third unit to 13 (7 + 6), and
so on. (See chart below for more details.)
Channel Mode
6 channels
10 channels
11 channels
16 channels
48 channels
57 channels
96 channels
ADJ Products, LLC - www.adj.com - 32 Hex Panel IP/32 Hex Panel IP Pearl User Manual Page 11
Unit 1 Unit 2
Address Address
1
1 11
1 12
17
1
49
1
58
1
97
1
Unit 3
Address
7 13
21
22
33
97
115
193

DMX Addressing

Unit 4
Address
19
31
32
49
145
172
289