Important Instructions - Gastroback Design Mincer Advanced Operating Instructions Manual

Please read all the advice and instructions with care and keep the manual.
The mincer is used for mincing meat (uncooked or cooked) and soft vegetables. Please
prepare the ingredients before filling them into the feed chute. Using the pusher you press
the food slowly into the worm which pushes it against the spinning crossed-blade knife.
The knife and the worm are driven by a 350 watt induction motor (max. 1,28 Nm).
The finished mince discharges through the grinding disc. The appliance has an overload
protection which prevents the motor from overheating.
The appliance is maintenance-free, very insusceptible and easy to use. All parts that
come into direct contact with food are easily to remove and easy to clean. No extra
tools are necessary for assembling or disassembling the appliance.

IMPORTANT INSTRUCTIONS

ATTENTION: Always ensure that the appliance is turned off (the control
switch should be in STANDBY position) before connecting the plug to the
power outlet.
• Never assemble or disassemble crossed-blade knife, worm or grin-
ding disc when the plug is connected to the power outlet to avoid
personal injury.
• Before first use rinse all the parts of the appliance with water that come
into contact with food and clean them with dishwashing detergent.
Note:
The display is illuminated only when the plug is connected to the power outlet. The
appliance will turn on only when the plug is connected to the power outlet.
ATTENTION:
sive chemicals (i.e. disinfectants, bleach) or cleaning pads for operation or
cleaning. Never clean or operate the appliance or parts of the appliance
with abrasive or hard sharp-edged items. Never put the motor housing or
the accessories in the dishwasher for cleaning! This will cause discoloura-
tion and corrosion and damage the motor.
• To avoid personal injury always turn the appliance off by turning the con-
trol switch to STANDBY, wait for the motor to stop completely and pull
the plug before assembling or disassembling, cleaning or moving the
appliance.
• While proceeding do not push the pusher too hard down to avoid blo-
cking the motor. Only use the provided pusher to guide food through the
feed chute.
26
To avoid damage, do not use any abrasive cleaners, corro-