Advertisement
Installation Instructions
WARNING: Make sure your cables do not run through a pinch
point.
E. Connect and secure power/audio/video cables, making
sure to leave sufficient slack to allow for movement of the
display.
VESA Compliant Recessed Mounting
A. Place four 1/2" X 3/8" Nylon spacers or four 1/2" X 3/4"
Nylon spacers, as necessary, over the mounting holes of
your display (see Figure 2).
B. Place the mount over the Nylon spacers, matching the hole
pattern on your display (75mm or 100mm) with the hole
pattern on the mount.
C. Using four M4 X .7 X 20mm Phillips pan head screws for
1/2" X 3/8" Nylon spacer installation or four M4 X .7 X
30mm Phillips pan head screws for the 1/2" X 3/4" Nylon
spacer installation, secure the mount to your display.
WARNING: Make sure your cables do not run through a pinch
point.
D. Connect and secure power/audio/video cables, making
sure to leave sufficient slack to allow for movement of the
display.
Non-VESA Compliant Mounts
A. Contact Chief Manufacturing for custom interface brack-
ets.
CABLE MANAGEMENT
WARNING: Make sure your cables do not run through a pinch
point.
1.
Route power/audio/video cables under each arm, allowing suf-
ficient slack in cables for extension and avoiding pinch points
2.
Secure cables using cover plates and four screws (see "DRAW-
INGS" on page 2).
4
Figure 2. Recessed Mounting
FPD
Advertisement
