Advertisement
Installation Instructions
ADJUSTMENTS
CAUTION: Overtightening adjustment will cause excessive wear.
Rotational Tilt, Pitch, and Roll Adjustment
1.
If necessary, use a Phillips screwdriver to tighten or loosen
the Phillips pan head screw (see DRAWINGS).
2.
Check for desired tension.
3.
Repeat Steps 1 and 2 until desired tension is obtained.
Lateral Tension Adjustment
1. Using a 3/16" hex wrench (provided), slightly tighten or
loosen lateral tension adjustment bolt (see DRAWINGS).
2.
Check for desired tension.
3.
Repeat Steps 1 and 2 until desired tension is obtained.
Arm Tension Adjustment
1.
Using a 3/16" hex wrench (provided), slightly tighten or
loosen arm tension adjustment bolt (see "DRAWINGS" on
page 2).
2.
Check for desired tension.
3.
Repeat Steps 1 and 2 until desired tension is obtained.
FPD
5
Advertisement
