Cable Management - CHIEF MFC Series Installation Instructions Manual

Installation Instructions
Tilting Display
The display can be tilted up to 15
from a straight upright position.
1. Turn knob counterclockwise on back of head assembly to
loosen the tilt. (See Figure 11)
1
Figure 11
2. Tilt display as desired, to a maximum of 15
or backward.
3. Turn knob clockwise to tighten display on head assembly.
(See Figure 11)
Tighten knob on back of head assembly to
CAUTION:
prevent damage when moving the cart and display.
4. If leaving the display in a straight upright position, it is
recommended that a bolt (not provided) be placed through
the head assembly (See Figure 11) to lock the display into
the upright position.

Cable Management

1. Signal cables can be run down the front flap of the center
post and out the front of the post at any of the openings.
(See Figure 12)
2. The display power cord can be run through the top and
down through the post to exit out the back. (See Figure 12)
3. Any accessory power cords can be run through the front
and down through the post to exit out the back.
Figure 12)
4. Install the snap-on covers (D) to any opening that is not
being used. (See Figure 12)
5. To remove the snap-on covers, grip the sides of the cover
in the middle and pull off. They can also be removed by
inserting a flat-blade screwdriver into the bottom slot and
rotating the screwdriver.
o
either backward or forward
3
lock display lock display
Place optional bolt
(not provided) here
4
to lock in an upright
position.
o
either forward
(See
(Front view
2
of center post)
3
1
Exits for
signal cables
(D)
Figure 12
MFC Series
(Rear
view of
center post)
Exit for
power
cables
9