Page 1
I N S T A L L A T I O N I N S T R U C T I O N S Instrucciones de instalación Istruzioni di installazione Installationsanleitung Installatie-instructies Instruções de Instalação Instructions d´installation Small Flat Panel Steel Stud Wall Mount Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description FWDSK110...
FWDSK110 Installation Instructions DISCLAIMER Failure to read, thoroughly understand, and WARNING: CSAV, Inc., and its affiliated corporations and subsidiaries follow all instructions can result in serious personal injury, (collectively, "CSAV"), intend to make this manual accurate and damage to equipment, or voiding of factory warranty! It is the complete.
Page 3
Installation Instructions FWDSK110 TOOLS REQUIRED FOR INSTALLATION AND PARTS 1/2" (Ø13mm) (3/16") A (1) D (4) B (4) C (2) (M4 x 20) E (4) (M4 x 12) F (4) (1/2" x 3/4") G (4) (1/2" x 3/8") H (4)
FWDSK110 Installation Instructions Site Requirements IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY WARNING: OR DAMAGE TO EQUIPMENT! The figure below identifies the minimum reguirements for installation of display mounts onto a steel stud structure. If the structure or its components do not meet these requirements contact the mount manufacturer for specific instructions before attempting installation.
Page 5
Installation Instructions FWDSK110 Mount Installation After determining the site meets the installation requirements: Drywall Identify desired mounting location on wall. 2. Using a stud finder or similar method locate studs. 3. Align mounting holes in mount with studs making sure Plastic Straps mounting holes are centered on studs.
Page 6
FWDSK110 Installation Instructions Display Installation Steel Stud The mounting holes on the back of your display will either be Drywall flush with the back surface, or recessed into the back surface. Refer to the applicable installation procedure. Plastic Cap Flush Mount Display...
Installation Instructions FWDSK110 2. Carefully place display face down on protective surface. 3. Determine depth of recessed mounting holes relative to back surface of display (against which Centris head will contact). (See Figure 8) 4. Select proper length spacer and screw.
Need help?
Do you have a question about the FWDSK110 and is the answer not in the manual?
Questions and answers