Symbols On The Appliance; Device Elements; Installation; Startup - Kärcher CV 30/1 Manual

Symbols on the appliance

Setting for long pile carpets
Setting for short pile carpets
Filter status indicator (see
"Troubleshooting -Remove the
blockage")
Identifies the access to the roll-
er brush in the side section (see
"Replacing the roller brush")
Type plate
Further important device specifications are
provided on the type plate. The type plate is
located on the rear of the device casing.

Device elements

Mains cable
1
Mains power cable connection
2
Suction pipe/suction hose
3
Brush head lock
4
Fibre height selection button
5
Filter cover
6
Filter cover lock
7
Main switch
8
Handle
9
Brush cover rotary lock
10
Side section bow
11
Side section
12
Filter bag lock
13
Filter bag
14
Motor protection filter
15
Filter casing
16
Exhaust filter
17
Suction hose at brush head
18
Handle adjustment
19
Cable hook, rotating
20
Cushion nozzle
21
Crevice nozzle
22
"Filter" indicator lamp
23
Indicator tuft
24
Roller brush
25
Install the loose parts for handle provided
with the device before using the device for
the first time.
See page 4 for illustrations
Handle with mains power cable
1
Handle metal tube
2
Suction pipe and suction hose
3
1. Open the handle adjustment.
2. Push the metal pipe of the handle into
the mount all the way to the lowest latch-
ing position (latches audibly twice).
3. Insert the handle into the metal pipe and
latch into place. Take care to ensure that
the mains cable is not jammed or twist-
ed.
4. Pull the handle to the first (uppermost)
latching position.
5. Close the handle adjustment.
6. Insert the suction hose into the connec-
tion nozzle.
7. Insert the suction pipe into the mount on
the device
Installing the filter bag
1. Unlock and remove the filter cover.
2. Turn the filter bag lock to the right to un-
lock.
3. Insert the filter bag and turn the filter bag
lock to the left to lock.
4. Fit and lock the filter cover.
Connecting the mains power cable
1. Open the cable holder at the handle.
2. Plug the mains cable provided into the
socket on the device.
3. Secure the plug connection against un-
intentional unplugging using the cable
holder on the handle.
Use only the mains cable provided and only
replace it with an equivalent cable in the
case of damage (see "Technical data").
English

Installation

Startup

to the device
13