Installing Sfps - Juniper E Series Hardware Manual

ERX 7.0.x Hardware Guide
2.
3.
4.
Figure 43: Possible Release Mechanisms on the SFP
5.
6.
7.
CAUTION: For port redundancy to operate correctly, both the primary and
redundant ports on a GE I/O module must use the same type of SFP.

Installing SFPs

To install SFPs:
90
Replacing SFPs on GE I/O Modules
Put the antistatic wrist strap on your wrist, and connect the strap to the
ESD grounding jack on the system.
Disconnect the cables from one of the SFPs on the module.
Identify the release mechanism for the SFP.
Different SFPs use different release mechanisms (see Figure 43). Possible
release mechanisms include:
A button that you press inward
A ring that you press inward
A bar that you pull sideways, then outward
A tab that you pull sideways, then outward
Release bar, button,
or tab
Release the SFP and pull it out of the slot.
Place the SFP in an antistatic bag.
If you are using the redundant port on the GE I/O module, repeat Steps 3
through 6 for the other SFP.
Transceiver
Release bar, button,
or tab
Release ring
Module faceplate