Connecting The Upper Link - Toro ProCore 864 Operator's Manual

3. Back the traction unit squarely up to the machine
until the lower link arms are aligned with the
hitch pins.
4. Engage the parking brake, shut off the engine,
and remove the key from the ignition. Wait for
the engine and all moving parts to stop before
leaving the operator's seat.
Note:
For maximum ground clearance, install
the hitch pins in the lower mounting holes of
the hitch plate for the machine
determine when to use the upper mounting
holes, refer to setup procedure
PTO Driveshaft (page
Figure 5
1. Top hole (hitch
plate—machine)
5. Insert the right and left lower link arms onto the
hitch pins (Figure
Figure 6
1. Lower link
6. Secure the lower link arms to the hitch pins with
the lynch pins (Figure
(Figure 5). To
4 Connecting the
11).
2. Bottom hole (hitch
plate—machine)
6).
2. Lynch pin
6).
3

Connecting the Upper Link

Parts needed for this procedure:
1 Link pin
1 Lynch pin
Procedure
Note:
For best aeration hole quality, align the front
of the machine vertical while operating it
Adjust the upper link to control this angle. Refer to
Operating Tips (page 27)
g028741
1. Connect the upper link to the lower hole in the
bracket and secure it with the link pin and the
lynch pin
g007292
1. Upper link
2. Link pin
10
for additional information.
Figure 7
(Figure 8).
Figure 8
3. Lynch pin
4. Locknut
(Figure 7).
g007293
g007294