Adjusting The Link Assembly; Reading The Documentation And Storing The Loose Parts - Toro Sand Pro 3040 Manual

1. Rear frame of the traction
unit
4. Pivot the locking lever to the right to lock the adapters
together.
4

Adjusting the Link Assembly

No Parts Required
Procedure
1. With the drag mat mounted and secured on the traction
unit, measure the gap between the top washer and the
spacer in the link assembly on the attachment adapter
as shown in Figure
The gap between the washer and the shoulder should
be 1.5 mm to 2.0 mm (0.060 to 0.080 inch); refer to
Figure 10.
1. 1.5 mm to 2.0 mm (0.060
to 0.080 inch)
2. Adjustment nut
Figure 9
2. Long leg of the lift-arm
assembly
10.
Figure 10
3. Jam nut
2. If the gap is not correct, loosen the jam nut and tighten
or loosen the adjustment nut on the link assembly as
needed to change the gap
5
Reading the Documentation
and Storing the Loose Parts
Parts needed for this procedure:
1 Operator's Manual
1 Parts Catalog
1 Clevis pin
1 Washer (0.469 x 0.922 inch)
1 Hairpin cotter
Procedure
1. Read the documentation.
2. Store the documentation in a safe place.
3. Store any loose parts for use when securing the
side-to-side pivot.
7
(Figure 10).