Table of Contents
Advertisement
Figure 10
ProCore 864
1. Lower PTO shield
2. Clip nut
2.
Assemble the PTO driveshaft to the gearbox
input shaft of the machine
(1/2 x 3.00 inches) and a nut (1/2 inch).
Figure 11
1. Gearbox input shaft
2. Nut
3. PTO shaft coupler
3.
Assemble the PTO driveshaft to the PTO output
shaft of the traction unit.
g007295
3. Screw
(Figure
11) with a bolt
g007296
4. Bolt
5. PTO driveshaft
1. PTO output shaft (traction
unit)
2. PTO shaft coupler
4.
Slide the PTO driveshaft forward as far as the
PTO output shaft allows.
5.
Pull back on the locking collar of the PTO shaft
coupler to secure the PTO driveshaft. Slide the
PTO driveshaft back and forth to ensure that it
is locked securely.
6.
On CE models only, connect the safety chains
from the driveshaft guards to the welded clips on
the link arms. Make sure that the chains remain
slack when the machine is raised or lowered.
7.
On the ProCore 864, install the lower PTO shield
to the machine.
8.
Verify that the telescoping tube has a minimum
of 76 mm (3 inches) overlap when the machine
is raised to the maximum height.
To check the overlap, measure the distance
between the end shields, as shown in
13. This dimension must not exceed 406 mm
(16 inches). If so, move the lower lift pins to the
upper set of holes before operating the machine.
1. 406 mm (16 inches)
12
Figure 12
3. PTO driveshaft
Figure 13
g007328
Figure
g007297
Hide quick links:
Advertisement
Table of Contents
