Connecting The Attachment To The Power Head; Adding Bar And Chain Oil To The Pole Saw - Toro 88714 Operator's Manual

You may need to rotate the chain-tensioning screw to fit the stud into the slot on the guide bar
(Figure 14).
6. Install the side cover and bar cover screw and loosely tighten the side cover by turning the screw clockwise.
7. Adjust the chain tension; refer to

Connecting the Attachment to the Power Head

1. Install the square shaft of the attachment into the square shaft of the power head (A of
2. Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts
together (B and C of
Note:
The locking button clicks into the slotted hole when the shafts are secured (C of
3. Using the screw-handle, tighten the screw on the shaft connector until it is secure (D of

Adding Bar and Chain Oil to the Pole Saw

Important:
Use only bar and chain oil (sold separately).
Fill the pole saw with bar and chain oil before first operation; refer to
Bar and Chain Oil (page
Adjusting the Chain Tension (page
Figure 4).
15).
Figure 4
Checking the Oil Level and Adding
10
16).
Figure
Figure
Figure
4).
4).
4).
g358795