Table of Contents
Advertisement
Figure 37
1. Spring retainer locknut
CAUTION
Springs are under tension, use caution
when adjusting or removing.
5.
Loosen and remove the 2 locknuts and washers
securing the rotalink damper for the #1 stomper
arm
(Figure
38).
Figure 38
1. Drive belt
2. Rotalink damper
3. Nut
6.
Lower the rotalink damper from the coring head
frame.
7.
Route the drive belt down through the coring
head frame and around the lower end of the #1
stomper arm
(Figure
4. Washer
5. #1 Stomper arm
38).
Installing the Belt
1.
Route the new drive belt around the lower end
of the #1 stomper arm and up through the coring
head frame.
2.
Position the drive belt onto the crank pulley,
under the idler assembly and over the drive
pulley.
3.
Raise the rotalink damper for the #1 stomper
arm to coring head frame. Ensure that the
damper spacers are installed in the same
position as in removal.
4.
Secure the rotalink damper to the coring head
with the 2 washers and locknuts previously
g007319
removed.
5.
Install and adjust the belt idler pulley and adjust
it to the appropriate tension.
6.
Install the dirt shield and the lower belt shield.
Adjust the lower shield to ensure clearance with
the belt.
7.
Install the pulley and the coring head covers.
g007320
33
Hide quick links:
Advertisement
Table of Contents
