Table of Contents
Advertisement
2.
Back the tractor squarely up to the aerator until
the lower link arms are aligned with the hitch
pins.
3.
Make sure that the PTO is disengaged.
4.
Engage the parking brake, shut off the engine,
and remove the key from the ignition. Wait for
the engine and all moving parts to stop before
leaving the operator's seat on the tractor.
Note:
For maximum ground clearance, the hitch
pins should be secured in the lower mounting
holes
(Figure
5). To determine when to use the
upper mounting holes, refer to setup procedure
4 Connecting the PTO Shaft (page
Figure 5
1. Top hole
5.
Insert the right and left lower link arms onto the
hitch pins
(Figure
Figure 6
1. Lower link
6.
Secure the lower link arms to the hitch pins with
the lynch pins
(Figure
11).
2. Bottom hole
6).
2. Lynch pin
6).
3
Connecting the Upper Link
Parts needed for this procedure:
1
Link pin
1
Lynch pin
Procedure
Note:
The front of the aerator must be vertical while
operating for best aeration hole quality
Adjust the upper link to control this angle. Refer to
Operating Tips (page 25)
g028741
1.
Connect the upper link to the lower hole in the
bracket and secure it with the link pin and the
lynch pin
g007292
1. Upper link
2. Link pin
10
for additional information.
Figure 7
(Figure
8).
Figure 8
3. Lynch pin
4. Locknut
(Figure
7).
g007293
g007294
Advertisement
Table of Contents
