Before Operation; Before Operation Safety; Outcross Traction Unit Controls; Adjusting The Aeration Depth - Toro ProCore 864 Operator's Manual

Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.

Before Operation

Before Operation Safety

General Safety
•
Never allow children or untrained people to
operate or service the machine. Local regulations
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
Always shut off the engine of the traction unit,
remove the key, wait for all moving parts to stop,
and allow the machine to cool before adjusting,
servicing, cleaning, or storing the machine.
•
Know how to stop the machine and shut off the
engine quickly.
•
Do not operate the machine without all guards
and other safety protective devices in place and
functioning properly on the machine.
•
Before operating, always inspect the machine to
ensure that the tines are in good working condition.
Replace worn or damaged tines.
•
Inspect the area where you will use the machine
and remove all objects that the machine could
strike.
•
Locate and mark all electrical or communication
lines, irrigation components, and other obstructions
in the area to be aerated. Remove the hazards, if
possible, or plan how to avoid them.
•
Ensure that your traction unit is suitable for use
with a machine of this weight. Check with your
traction unit supplier or manufacturer.
Outcross Traction Unit
Controls
Refer to the Outcross traction unit Operator's Manual
for information on controls and operation, as well as
additional information on setting up the machine.
Adjusting the Aeration
Depth
Important:
Adjust the aeration depth only when
the traction unit is parked, the parking brake is
engaged, the PTO is disengaged, and the engine
is shut off.
1. Lay the desired tine onto the depth decal while
aligning the tine tip with the desired aeration
depth as shown in
2. Determine the letter setting aligned with the
mounting end of the tine
depth control to the corresponding letter on the
decal.
3. Insert a 9/16-inch socket with a ratchet onto the
depth adjuster input shaft
21
Figure 22.
Figure 22
(Figure 22). Adjust the
(Figure 23).
decal106-8856