Removing The Machine From The Traction Unit - Toro ProCore 864 Operator's Manual

Removing the Machine
from the Traction Unit
Important:
Refer to the PTO driveshaft owner's
manual for additional operating and safety
information.
1. Park the traction unit and machine on a level
surface, disengage the PTO, engage the parking
brake, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving
the operator's seat.
2. Install the storage stands and secure them to
the machine with the lynch pins
Figure 42
(Figure
g007323
1. Lynch pins
Note:
shipping pallet.
3. Slowly lower the machine until the storage
stands contact the ground.
4. Loosen the locking nut and rotate the upper
adjusting link to release the tension between the
machine and the traction unit.
5. Remove the lynch pin and the top link pin
securing the center link to the bracket. Retain
the lynch pin and the top link pin with the
machine.
43).
6. Disconnect the safety shield chains from the
traction unit PTO (CE only).
7. Pull back on the lock collar to disconnect the
PTO driveshaft from the PTO output shaft on
the traction unit.
8. Slide the PTO driveshaft back and remove it
from the traction unit.
9. Support the PTO driveshaft by connecting the
PTO tether to the PTO shield to prevent the
driveshaft from contacting the ground
44).
35
Figure 43
2. Storage stand
You can store the machine on the original
g007302
(Figure