Sw2 Dip Switch; End Of Line (J1 Jumper) - golmar GTWIN T-5924 User Manual

T-5924 GTWIN TELEPHONE
TELEPHONE SETTINGS

SW2 DIP switch:

The DIP switch is located in the central part of the circuit, accessible by opening the
SW2
telephone. It enables the telephone to be configured as master/slave.
INT: Internal code of the telephone to set as master/slave.
Set the monitor/telephone as master, slave 1, slave 2 or slave 3 using the SW2 DIP switch with
a code from 0 to 3 respectively. Taking into account the following points:
In the case of a single telephone in the apartment, the code to be set will always be 0.
Ÿ
In apartments, up to 4 telephones can be connected in parallel, all with the same user code but with different
Ÿ
internal telephone codes.
The internal code is used to identify each of the telephones in the same apartment. This enables intercom calls to
Ÿ
be made to a specific telephone in the same apartment. In the case of intercom calls to different apartments, and in
the case of calls coming from door panels and from apartment front doors, all of the telephones in the apartment
always ring. The following considerations must also be borne in mind:
When master telephone 0 receives a call, it rings immediately and slave telephones 1, 2 and 3 ring in succession,
Ÿ
one after the other.
( )
Factory setting.
*

End of line (J1 jumper):

The J1 jumper is located in the central part of the circuit, accessible by opening the
telephone. It enables the end of line to be set.
Leave the J1 end of line jumper inserted in the telephones in which the Bus cable
ends.
Remove the J1 end of line jumper on all of the intermediate telephones.
SW2 DIP SWITCH:
ON ON ON
1 2 1 2 1 2
( )
*
INT 0 INT 1 INT 2
ON
1 2
INT 3
8
SW1
SW1
JP1 SW2
SW2
SW1
JP1 SW
SW2