Function Buttons; Sw1 Dip Switch - golmar T-540 PLUS SE User Manual

T-540 PLUS SE TELEPHONE
DESCRIPTION OF THE TELEPHONES
Function button:
One short press for 1 second, with the telephone in standby and the handset on the hook,
activates ringtone volume mode, with a tone indicating the volume selected. Then
each 1 second press (before 5 seconds elapse) selects a ringtone volume level and so
on (in carousel mode) with the following selections (maximum, medium, minimum and
no volume "night mode". Note: The "night mode" status LED blinks red . During a call
process, the telephone will emit a ringtone and exit volume mode.
Regardless of the volume selected, the "apartment interior door call" ringtone will always sound at the
highest level.
One long press for 3 seconds, with the telephone in standby and the handset on or off the hook, turns the
telephone on or off. After any resetting of the telephone and for the following 45 seconds, no operation
with it can be performed.
( )
With the handset off the hook, the intercom (in the same apartment) is activated. One long press until a
*
confirmation tone can be heard will call all of the telephones in the apartment. To call individual
telephones, press the button once to call the master telephone, twice to call slave 1", 3 times to call
" slave 2", 4 times to call slave 3" and 5 times to call slave 4". This selective intercom call mode is only
available with the T540 Plus SE telephone and the Tekna Plus SE monitor. This only functions if no call or
communication is in progress.
( )
Regardless of the position of the handset, the auxiliary device is activated.
*
With the handset hung up, a panic call to the guard units configured to receive such calls is made. With the
handset off the hook, a normal call can be made to the main guard unit. During call reception and
communication processes, it enables the door release to be activated.
( )
In advanced programming mode (see p. 9), the default functions of function buttons
*
one of the following functions at the same time and per button: ("A1" auxiliary device activation, call to secondary
guard unit, auto switch-on or intercom).
Description of the SW1 DIP switch:
Ethe SW1 DIP switch is located in the central part of the circuit, accessible
by opening the telephone.
It enables the telephone to be configured as master/slave and an address
to be assigned to it.
Important: This type of programming cannot be performed on a general entrance door panel.
Switch number:
Value when ON:
*Factory setting
"
DIP 1 and DIP 2: Configure the telephone as master/slave. DIP 1 and DIP 2 to OFF master,
DIP 1 to OFF and DIP 2 to ON slave 1, DIP 1 to ON and DIP 2 to OFF slave 2, DIP 1 and
DIP 2 to ON slave 3.
DIP 3 to DIP 10: To configure the telephone address.
The switches set to OFF have a zero value.
The values of the switches set to ON are shown in the table below.
The telephone code is the sum of the values of the switches set to ON.
3 4 5
128 64 32 16
" "
"
6 7 8 9 10
8 4 2 1
)
"
and can be changed with
Example: 0+ 64+0+16+0+4+2+1=87
5
SW1