Warning Messages - Nederman FlexPAK Series Instruction Manual

GB
1. Press OK.
2. Step forward with to the character to be changed.
4
3. Select an appropriate value with
seconds.
4. Confirm the change with OK.
FltClean
Th = 01:00s
TI = 60:00m
Ta = 00:00
ESC OK
Setting the time for the automatic cleaning func-
tion.
1. Press OK.
2. This it the time that the filter cleaning plate is open.
Step forward with 4 to the character to be changed.
3. Select an appropriate value
4. Step forward with to Tl which is the time between
4
filter cleaning. Select character to be changed. Time
is shown in minutes.
5. Select an appropriate character with
6. Confirm the change with OK.
SSR_Time
T = 10:00m
Ta = 00:00
ESC OK
Setting the post-running-time
1. Press OK.
2. This is the time the unit runs before it stop. Select
required character with
3. Select an appropriate value with
shown in minutes.
4. Confirm the change with OK.
Nederman
FlexPAK
TmeToService
2000Hour
OK
ESC
Start display.
NEDERMAN
Standby
TmeToService
2000Hour
ESC OK
Unit in waiting position.
or , time in
5 6
PLC-12
or .
5 6
or .
5 6
PLC-13
.
4
or . Time is
5 6
PLC-1
PLC-14
RUNNING
-20 kPa
TmeToService
2000Hour
ESC OK
The unit in operation. The unit´s current vacuum is
shown in the display, e.g. -20kPa

Warning messages

Time for
Service
2004-10-25
ESC OK
Time for service, date shows when the message was
activated.
CAS <3bar
TH 16:00
Reset OK
ESC OK
Connected compressed air below 3 bar. TH 16:00 is the
weekday and the time the fault was activated.
Fan Hi Temp
TH 01:00
OK
ESC
Fan temperatur to high.
The unit goes into a cooling mode with a lower vacuum
level.
Dustbin
Full
TH 01:00
Reset OK
OK
ESC
If a sensor for level indicating is installed this message
is shown when the collector bin is full. The time the unit
should run between varning and alarm can be adjusted.
In alarm mode the unit stops.
GB
PLC-15
PLC-19
PLC-20
PLC-25
PLC-26
7