Table of Contents
Advertisement
NCA-5220 User Manual
Follow the instructions below to connect the DC power cord to the connector on the PSU.
1. Loosen the two screws indicated in the picture.
2. Respectively attach the two cables to the connectors: the red cable to the right (Positive Pole) and the
black cable to the left (Negative Pole).
3. Fasten the screws.
4. Connect the power cables to the power source.
This product is intended to be supplied by a UL Listed DC power source, rated -36 －-72V, 12-6A
minimum (each), Tma = 40 degrees C, and the altitude of operation = 5000m.
The cable should be 14AWG (12A minimum, 72V minimum).
If you need further assistance with purchasing the power source, please contact Lanner Electronics Inc. for
further information.
+
-
46
Power
Source
Advertisement
Table of Contents
