Table of Contents
Advertisement
NCA-5220 User Manual
The HDD/SSD bay supports 2 x 2.5" SATA HDDs or SSDs as data storage. Please follow the steps below for
installation.
1. Locate the disk drive tray at the corner of the system. Loosen the screw indicated in the picture and slide
the tray downwards to have it loosened from the four latching spots. Take the tray out and prepare to
install SATA 2.5" disk drives.
2. Place the disk drive in the tray, as shown in the image below. Apply two disk screws with two rubber
washers for each side of the disk drive. If you are going to install two disks, always start by installing the
disk in the lower slot.
SATA Contact
36
Advertisement
Table of Contents
