Fig. 30: Panel Mounting For V Panel Express Systems - Kontron V Panel Express 121 User Manual

9. Installation Instructions
The mount clamps with screws (supplied), allow the easy and fast mounting of the V Panel Express-121/150/170/190
V Panel Express into an instrument panel or wall panel.
Dimension for: V Panel Express
Rear side display box enclosure
[mm] (W x H x D)
Cut-Out for Mounting into a
Panel [mm] (W x H)
Requirements for Mounting
Metal mounting panel
thickness for proper mounting
Used clamps with screws for
mounting the V Panel Express
to a panel
Required Tool
Proper Torque
Mounting Position
Table 1: Requirements for V Panel Express mounting into a subframe/panel
In order to ensure IP65 front sealing against dust and water, mount the system on a non-textured
surface. Before you install the V Panel Express system into a panel or a subframe for industrial cabinet,
verify the perfect condition of the seal at the rear of the front plate. The seal has to be in place without
injury/defects and dirt.
3
4
5
1 Front panel of the V Panel Express with seal
2 Display Box Enclosure
3 PC-Box of the V Panel Express
32
121 VPE 150 VPE
324 x 324x 41.25 406.4 x 311x 34.25
327 x 266 409 x 314
1.5 – 6 1.5 – 6
6x
Tighten the screws with a torque of 0.5 Nm
Ensure the vertical and horizontal alignment of the system/display box.
1

Fig. 30: Panel mounting for V Panel Express systems

4 Mounting clamps with screws for system installation into a
subframe/panel
5 Example of subframe for system installation
V Panel Express – User's Guide (V1.01)
170 VPE
418 x 356 x 41.5
421 x 359
1.5 – 5
8x
Allen Wrench 2 mm
190 VPE
460 x 380x 42
463 x 383
1.5 – 9
2 4
5
www.kontron.com