Kontron V Panel Express 121 User Manual page 30

8. Accessing Internal Components
Legend for the figures Fig. 20, Fig. 21, Fig. 22, Fig. 23, Fig. 24 and Fig. 26:
1 Installed HDD tray (removable)
2 Captive knurled screws that secure the drive tray to
the chassis
3 Location for the drive connectors (power and
SATA) on the rear of the drive tray (if HDD is
installed into the tray)
4 Location for the 2.5" HDD drive (SATA 0)
5 Location for the 2.5" HDD drive (SATA 1)
6 HDD mounting screws on the left side of the drive
tray
In order to reinstall a new 2.5" SATA drive into the "SATA 0" drive location or to expand your system with a second
2.5" SATA drive into the "SATA 1" drive location proceed as follows:
8. Remove the drive tray as described in the steps 1-7.
9. Insert the new 2.5" SATA drive into the "SATA 0" drive location or a second one into the "SATA 1" drive location (refer
to, Fig. 21, pos. 3, pos. 4 and pos. 5). Fit the "SATA 0" drive location always first if your system has to be operating
with one HDD drive only (refer to Fig. 21, pos. 4)!
10. Make sure the drive has been fitted properly into the drive tray and secure the drive using the retained screws
(step 6). The screws for securing the second HDD (for SATA1 location) into the drive tray are not included
(refer to Fig. 26).
11. Insert the hard disk tray into the systems HDD tray, by slightly pressing inwards.
12. Trough the access door connect inside of the unit, the SATA cable and the SATA power connector to the rear of the
HDD (refer to Fig. 21, pos. 3).
13. Close the access door and secure it with the knurled screw (Fig. 13, pos. 2).
14. When the drive/s is/are lined up correctly, secure the drive tray to the chassis with the captive knurled screws
(see Fig. 8, pos. 10).
28
V Panel Express – User's Guide (V1.01)
7 2.5" SATA HDD installed as "SATA 0" into the drive
tray
8 Upper cut-out for HDD connector (power and SATA)
for the "SATA1" drive (not included)
9 Drive tray for up to two 2.5" SATAII drives
10 HDD mounting screws on the right side of the drive
tray
11 Mounting holes for the second HDD (HDD is not
included)
www.kontron.com