Installation Instructions - Kontron V Panel Express 121 User Manual

9. Installation Instructions

9. Installation Instructions
Expansion card installation should be performed before installing the V Panel Express to a wall.
The V Panel Express has to be installed and operated only by trained and qualified personal.
In order to ensure the IP65 protection class at the front side, make sure that the USB connector on the
front panel is covered by the elastic captive rubber coat.
The mounting and operation of the V Panel Express is only the vertical position with the interfaces
downwards.
The unit must be placed such that there is sufficient space for connecting the cables to the I/O interface
connectors and for operating the power button.
Leave at least 5 cm (approx. 2") of free space around the unit to prevent the device from possibly
overheating! Do not obstruct the air intake and exhaust openings.
The voltage feeds must not be overloaded. Adjust the cabling and the external overload protection to
correspond with the rated voltage range indicated on the type label.
The type label is located on the right side of the system.
The access door and HDD drive tray must be secured by the captive knurled screws during operation.
All V Panel Express system configurations are delivered with the mounting clamps and the Allen screws (refer to Fig. 28,
pos. 3 and pos. 4) as accessories. These mounting clamps have to be used in order to install the system into a subframe or
a panel.
1
2
4
5
1
2
Fig. 29: Detai top sidel: Systems without mounting clamps (shown as a detail of a15" display box)
Legend for Fig. 28 and Fig. 29:
1 Display Box enclosure
2 Rear side of the front panel with seal
www.kontron.com
Fig. 28: Detail top side: Systems delivering status with mounted clemps
(shown as a detail of a15" display box)
3 Mounting clamps (for systems with 15" and 17" display)
4 Allen screws (M4)
5 Pair slots for mounting clamps
V Panel Express –User's Guide (V1.01)
3
4
5
31