Selection And Qualification Of Personnel; Notice On Safety During Operations - Phoenix Mecano DEWERT OKIN DUOMAT 7 HOME Installation Instructions Manual

DUOMAT 7
2.3

Selection and qualification of personnel

This drive should only be installed into the end product by someone who has completed training in
electronic motor assembly or has equivalent qualifications.
You should only install this drive when you are qualified to do so. Otherwise, a properly qualified
person should be found for this task.
2.4

Notice on safety during operations

Basic safety rules must be followed in order to ensure that the end product can be continually op-
erated in a safe manner. These rules must be observed while using the end product and while in-
stalling the drive.
These rules and safety measures can be categorized as follows:
 Construction measures before the installation (refer to the "Ensuring operational reliability dur-
ing installation" section in the chapter "Installation").
 Safety fundamentals during the drive installation and during cable and wire routing (refer to the
"Safety notices to observe during installation" section in the chapter "Installation").
 Using the drive in intermittent duty (refer to the "General notices" section in the chapter "Notices
for Operation").
 Basic safety rules during operation (refer to the chapter "Notices for Operation").
 The creation of a manual for the end product which contains these and other safety rules.
Creating a user's manual
The manufacturer of the end product must create a manual for the user of that product. The safety
notices in the end-product manual must be written based on the end product's risk assessment.
43170 6.0
Safety Notices
11