Installation; Safety Notices To Observe During Installation - Phoenix Mecano DEWERT OKIN DUOMAT 7 HOME Installation Instructions Manual

DUOMAT 7
6.

Installation

6.1

Safety notices to observe during installation

Basic safety rules must be followed in order to ensure that the end product can be continually op-
erated in a safe manner. These rules must be observed while using the end product and while in-
stalling the drive.
6.1.1 Ensuring operational reliability during installation
The safety and reliability of the end product containing the DewertOkin drive can be ensured by us-
ing the proper construction methods described below.
Avoiding fatigue fractures
Drives that are incorrectly installed can undergo fatigue fractures which then create a
risk of injury.
 Install the drive in the end product so that it is properly aligned. This will help pre-
 Do not position the drive at a slanted angle when installing it in the end product. A
Avoiding a pinching hazard
When designing your end product, you should take the drive adjustment movement
into account with passive safety mechanisms and with the appropriate safety notices in
your operating instructions.
 Installation methods for ensuring passive safety: Install the DUOMAT 7 so that none
When preparing safety notices for the operator, make sure that your operating instructions inform
the user of these points.
43170 6.0
CAUTION
vent shear stress.
slanted angle between the intended direction of movement of the end product and
the drive's direction will create shear stress and could lead to a fatigue fracture.
CAUTION
of the positions where shear and pinch hazards exist are accessible externally.
Installation
19