Combination Possibilities; Layout Of System Connections - Phoenix Mecano DEWERT OKIN DUOMAT 7 HOME Installation Instructions Manual

Combination Possibilities

3. Combination Possibilities
The DUOMAT 7 can be combined for use with other single or double drives. The following basic
combinations are possible:
 a DUOMAT 7 with a operating element,
 a DUOMAT 7+1 as the main drive and a single drive used as a slave drive with a operating
element,
 a DUOMAT 7+2 as the main drive and two drives used as slave drives with a operating ele-
ment.
Systems can be customized by combining drives with the handset or hand-held remote control and
control units as needed. The system components must be connected in a specific order.
DewertOkin has separate system instruction manuals containing all information and instructions
needed for these systems.
 Only a DewertOkin device should be used to control the drive since they have already been ver-
ified to work together.
3.1

Layout of system connections

Refer to the sticker on the drive for details about layout and positioning of the connections. The
sticker is located under the sockets. It indicates the proper type of connections for the drive. The
actual connection layout depends on the specifications of the particular system. An example sys-
tem shown in Figure 3 shows the location of this sticker.
Figure 3
A Layout of connections
NOTICE
Only connect the components according to the specifications found on the drive stick-
er. Any other arrangement of connections may damage the drive.
14
An illustration of where the connection layout sticker is positioned on the drive
A
DUOMAT 7
43170 6.0