Installation Procedure - Phoenix Mecano DEWERT OKIN DUOMAT 7 HOME Installation Instructions Manual

Installation
6.2

Installation procedure

6.2.1 An example installation
Optional rechargeable battery

NOTICE
Take care not to damage the battery cable while unpacking the drive. The battery does
have a residual charge.
Before installing the drive, make sure that you are observing all of the safety notices found in the
"Safety notices to observe during installation" section.
Electrical components should be connected or disconnected only when the mains
power cord and the battery plug (when present) are unplugged.
1 Move your product into a position where it is supporting no load.
Be sure to carry out work on the drive in a position so that no loads are bearing on it.
Only in this way can you be sure to avoid any risks or crushing or injury.
2 Remove the shield cover and disconnect the battery (when present).
For the optional rechargeable battery: pull the battery cable out of the socket on the
DUOMAT 7. The "Electrical connection" section contains more information about taking
out the rechargeable battery.
3 Pull out the optional snap-in locking device (refer to in Figure 4) until it reaches the end stop.
20
CAUTION
Disconnect the battery plug from the socket before installation. The battery is con-
nected when the drive is delivered. The battery must be unplugged to ensure that
the drive does not accidentally activate.
CAUTION
CAUTION
CAUTION
DUOMAT 7
43170 6.0