HP ESA-E Series Programmer's Manual page 331

HP 8590-Series
Analyzers
Command(s)
MKPX
MKPX <value> :CALCulate:MARKer:PEAK:EXCursion <rel_ampl>
MKPX UP|DN
MKPX? :CALCulate:MARKer:PEAK:EXCursion?
MKREAD
MKREAD FRQ :CALCulate:MARKer[1]|2|3|4:X:READout
MKREAD SWT FREQuency|TIME|ITIMe|PERiod
MKREAD IST
MKREAD PER
MKREAD FFT
MKREAD? :CALCulate:MARKer[1]|2|3|4:X:READout?
Corresponding SCPI Command(s) Description/Comments
Specifies the minimum signal excursion for
the spectrum analyzer internal
peak-identification routine.
Specifies the minimum signal excursion for
the analyzer internal peak identification
routine to recognize a signal as a peak.
This applies to all traces and all windows.
The HP 8590-Series analyzer outputs data
in the format: 6.00. The HP ESA analyzer
outputs data in the format:
+6.00000000E+000.
Selects the type of active trace information
displayed by the spectrum analyzer marker
readout.
Selects the units for the x-axis readout of
the marker. Available units are: frequency,
time, inverse of time, period.
FFT is an invalid parameter for the
HP ESA spectrum analyzers.
The HP 8590-Series analyzer returns
marker readout in the format: FRQ SWT
IST or PER. The HP ESA analyzer returns
FREQ, TIME, ITIM, or PER.