HP ESA-E Series Programmer's Manual page 320

HP 8590-Series
Analyzers
Command(s)
LIMIFAIL
:CALCulate:LLINe[1]|2:FAIL?
LIMIFT
:CALCulate:LLINe:CONTrol:DOMain FREQuency|TIME
LIMIHALF
<no equivalent SCPI command>
LIMIHI
<no equivalent SCPI command>
LIMILINE
:CALCulate:LLINe[1]|2:DATA?
:CALCulate:LLINe[1]|2:MARGin?
:CALCulate:LLINe[1]|2:MARGin:STATe?
LIMILO
<no equivalent SCPI command>
Corresponding SCPI Command(s) Description/Comments
Returns a "0" if the last measurement sweep of
trace A is equal to or within the limit-line
bounds.
Selects how the limit-line segments are placed
on the spectrum analyzer display, according to
frequency, or according to the sweep time
setting of the spectrum analyzer.
Edit/specify upper or lower limit line only.
There is no similar function in HP ESA
analyzers.
Allows you to specify a fixed trace as the upper
limit line.
There is no similar function in HP ESA
analyzers.
Outputs the current limit-line table definitions.
Allows you to specify a fixed trace as the lower
limit line.
There is no similar function in HP ESA
analyzers.