HP ESA-E Series Programmer's Manual page 29

6. Press
Printer Type
make the analyzer attempt to identify the connected printer. When
you press , the analyzer will respond in one of the three
Auto
following ways:
• The
Print Setup
and no new message will be displayed in the display status line.
This indicates that the analyzer has successfully identified the
connected printer and no further setup is required. As long as
remains selected in the
Auto
attempt to identify the printer when the front panel
pressed.
• The
Print Setup
selected and one of the following diagnostic messages will be
displayed in the display status line:
Unknown printer, Define Custom to set up printer
No printer response, Define Custom to set up
printer
Invalid printer response, Define Custom to set up
printer
This indicates that the analyzer was unable to automatically
identify the connected printer, and
the
Printer Type
specific printer characteristics such as the printer language
(PCL3 or PCL5) and color printing capability. Once you have set
these characteristics to match those of your connected printer, the
printer setup process is complete. As long as
selected in the
automatically identify the connected printer when the front panel
key is pressed.
Print
• The
Print Setup
and the following message will appear in the display status line:
Unsupported printer, Printer Type set to None
This indicates that the analyzer has successfully identified the
connected printer, but the printer is not supported by the
analyzer. As long as
analyzer will respond to any print command by displaying the
message Printer Type is None in the display status line.
Chapter 1
to access the
Printer Type
menu will be displayed with the
Printer Type
menu will be displayed with the
Custom
menu. Press
Print Setup
menu, the analyzer will not attempt to
Printer Type
menu will be displayed with the
is selected in the
None
Programming Fundamentals
Printer Setup and Operation
menu keys. Press
Auto
key selected
Auto
menu, the analyzer will
key is
Print
key
Custom
has been selected in
, to select
Define Custom
remains
Custom
key selected
None
menu, the
Printer Type
to
1-15