HP ESA-E Series Programmer's Manual page 301

HP 8590-Series
Analyzers
Command(s)
BTC
:TRACe:COPY TRACE2, TRACE3
BXC
:TRACe:EXCHange TRACE2, TRACE3
CAL
CAL ALL :CALibration:[ALL]
CAL AMP :CALibration:AUTO:MODE ALL|NRF
CAL ON/OFF :CALibration:AUTO[:STATe] OFF|ON|0|1
CAL TG :CALibration:TG
CAL YTF :CALibration:RF
CAL INIT :CALibration:DATA:DEFault
CAL FREQ :CALibration:FREQuency[:STATe] OFF|ON|0|1
Corresponding SCPI Command(s) Description/Comments
Transfers trace B into trace C.
Transfers TRACE2 (trace B) into TRACE3
(trace C).
Exchanges trace B and trace C.
Exchanges TRACE2 (trace B) with TRACE3
(trace C), point by point.
Initiates self-calibration routines.