Table of Contents
Advertisement
9. Installation with bolt switching contact
a) General information
The bolt switching contact must be mounted into the strike plate on the entrance
door.
When the door is locked (upon turning the key) the bolt switching
contact is closed, which causes the alarm system to be set to
'externally armed'. When the door is unlocked, the contact opens
and automatically disarms the alarm system ('disarmed').
Bolt switching contacts are available as simple normally open contacts or as
change-over switches. Both versions can be used with the 'FAZ 3000-SE-2'
activation switch, as only the normally open contact command is applied.
The bolt switching contact best suited to your entrance door should be available
from the door's manufacturer.
Irrespective of what your case may be, the installation is best
entrusted to a specialist tradesperson in order to guarantee
problem-free functionality.
Alterations to the strike plate or door frame require corresponding expertise.
Amateur installation attempts can cause damage to the door opening
mechanism and the door frame, which may incur expensive repairs!
These are disproportional to the cost of a professional tradesperson, who also
gives a guarantee on any work carried out.
10
Advertisement
Table of Contents
