Table of Contents
Advertisement
• The activation switch should be installed in a dry indoor area (not in a damp
cellar or a bathroom, for example).
• Choose a secured area so that intruders cannot quickly tamper with the
device. The installation location should neither be immediately visible from
outside the house nor from within the house.
• There are two ways in which you can visually check the state of the alarm
system from the outside:
1. You can install the activation switch so that the two LEDs on the casing
of the activation switch are visible from the outside, through the glass
pane of a door, for instance. This, however, is contrary to the idea that
the installation location should not be immediately recognisable; see
above.
2. Inside the activation switch there is an option to connect two LEDs. When
a button is pressed these signal the state 'disarmed' or 'externally armed'
in the same way the two LEDs on the casing do. The LEDs can be installed,
for example, in the key switch/button casing.
21
Advertisement
Table of Contents
