D) Registering The 'Faz 3000-Se-2' With The Alarm Base Station - Conrad Electronic FAZ 3000-SE-2 Operating Instructions Manual

d) Registering the 'FAZ 3000-SE-2' with the alarm base
station

To register an activation switch the alarm base station must first
be set to receive radio signals. Make sure that you also read the
user manual of the 'FAZ 3000-Z' alarm base station.
Carry out the following steps on the 'FAZ 3000-Z' alarm base station:
Description of procedure
• The alarm base station must be in the top level. The
LCD should appear as on the right, for example,
with the time and the date.
• Briefly press the 'Menü a/A' button on the control
unit of the 'FAZ-Z' alarm base station.
• Use the ' ' and ' ' buttons to select the 'sensors
menu.
• Confirm your selection by briefly pressing the 'OK'
button. 'sensors add sensors add' appears on the LCD.
sensors add sensors add sensors add
• Press the 'OK' button again.
The 'X X X X X ' character here stands for the number of
sensors that have already been registered plus
one.
• Keep pressing the ' ' button until the display shown
on the right appears on the LCD.

Now the alarm base station is ready to receive and the 'FAZ 3000-
SE-2' activation switch can be registered. A maximum of four of
the activation switches can be registered with the alarm base
station.
14
sensors sensors' sensors
sensors
Display on LCD
disarm
16:30 14.12
troubles
sensors
sensors
add
sensor
clear
rem. sw.
clear
X
1