Opening The Casing Of The 'Faz 3000-Se-2 - Conrad Electronic FAZ 3000-SE-2 Operating Instructions Manual

7. Opening the casing of the 'FAZ-SE'
• Open the casing; the two casing halves are secured by two catches ('A' in
figure 1 below).
Using a flat-headed screw driver, carefully press the two catches about a
millimetre inwards, until you are able to open the casing:
First press one catch inwards and pull the casing approx. 1-2 millimetres
apart at this location. Then press the other catch inwards; the casing now
opens.
• The hole 'B' is used for mounting the device with screws. The two openings
marked 'C' are used to feed cable into the activation switch.
• The cables should be inserted before the
activation switch is mounted at the intended
installation location (see following page).
Two openings ('C') are found on the reverse
of the activation switch, through which the
cables should be fed inward.
When fastening the activation switch into
place, make sure the cables are not bent or
jammed.
Do not straighten any of the
components or additional
PCBs just so that it 'looks
better'.
8
A
B
C
A
Figure 1