Table of Contents
Advertisement
• The LEDs are connected as shown in figure
10. Make sure that you connect the red and
green LEDs correctly, so that they light up like
the LEDs that are already built-in.
Terminals from KL2:
Left connection:
Middle connection:
Right connection:
Do not invert the polarity of the LED pins,
otherwise the respective LED will not light up.
Figure 11 shows you how to connect them
properly.
The shorter pin identifies the cathode ('-') and
the longer pin identifies the anode ('+').
Series resistors are already integrated onto
the circuit board of the activation switch,
which means that the LEDs can be connected
directly.
• Do not insert the batteries yet. The casing should remain open at first.
GND/earth
+ for red LED
+ for green LED
KL2
Red
Rot
Grün
Green
Figure 10
Figure 11
23
Advertisement
Table of Contents
