Functionality - Conrad Electronic FAZ 3000-SE-2 Operating Instructions Manual

6. Functionality

The radio controlled activation switch 'FAZ 3000-SE-2' is used to arm the 'FAZ
3000-Z' alarm base station via various switches/buttons.

This allows the alarm control centre to be activated or deactivated
simply by closing the entrance door – by means of a bolt switching
contact in the door's strike plate – or via an external key switch.
One of the various following components can be connected to the 'FAZ 3000-
SE-2':
• Bolt switching contact (1 x on, contact on/off)
• Key switch (1 x turn; single-pole, change-over contact)
• Key button (1 x turn; single-pole, change-over contact)
The activation switch is equipped with an additional sabotage contact for the
connection of external key switches.

This can be connected with the sabotage contact on the key switch
casing. It then automatically triggers a sabotage alarm via the
alarm base station if the key switch's casing is opened without
authorisation.
There is a further sabotage contact in the activation switch's own casing. This
automatically triggers a sabotage alarm via the alarm base station if the
activation switch's casing is opened without authorisation.
Two external light-emitting diodes (LEDs) may be connected to signal the
current status of the alarm base station ('armed' or 'disarmed'). If these are,
for example, integrated into the casing of a key switch, the alarm base station's
current status is immediately externally visible.
7