Cleaning The Spraying Arm; Complete Cleaning; Protection Against Frost Damage - Hanseatic WQP12-7635R User Manual

Cleaning the spraying arm

The nozzles in the spraying arm may calcify
or become dirty due to food scraps. Check
the nozzles regularly and clean them if re-
quired.
1. Empty both dish racks and remove the
lower dish rack.
2. Pull the lower wash arm up and off.
3. The upper spraying arm is affixed using
a bayonet closure. In order to remove the
spraying arm, hold both of the toothed
bayonet holders still and turn the spraying
arm in a clockwise direction.
4. Clean the nozzles under running water.
5. Affix the spraying arm again after cleaning.
The spraying arm must be firmly affixed
and must be able to rotate freely.
Care and maintenance

Complete cleaning

In well-stocked supermarkets and drugstores,
you will find special dishwasher cleaning
products. Cleaning the appliance using these
products takes place when the dishwasher is
empty and is very intensive. You should clean
the dishwasher in this way from time to time.
When doing so, please note the manufactur-
er instructions on the packaging.
Protection against frost
damage
Position the dishwasher in a room which is
protected from frost, if possible. If this is not
possible, protect the dishwasher against frost
as follows. You will need a shallow dish or a
pan, and a sponge.
1. Disconnect the mains plug from the sock-
et or switch off the fuse.
2. Close the tap and unscrew the inlet hose
(36).
3. Let the water from the inlet hose flow
completely into the dish.
4. Remove the filters.
5. Remove water from inside the appliance
using a sponge.
Page EN-23