Cleaning The Spraying Arm; Complete Cleaning; Protection Against Frost Damage - Hanseatic WQP12-7735B User Manual

Cleaning the spraying arm

The nozzles in the spraying arm may calcify
or become dirty due to food scraps. Check
the nozzles regularly and clean them if re-
quired.
1. Empty both racks and remove the lower
rack.
2. Pull the lower spraying arm up and off.
3. The upper spraying arm is fastened using
a bayonet closure. In order to remove the
spraying arm, hold both of the toothed
bayonet holders (29) still and turn the
spraying arm in a clockwise direction.
4. Clean the nozzles under running water.
5. Affix the spraying arm again after clean-
ing.
The spraying arm must be firmly affixed
and must be able to rotate freely.
Care and maintenance

Complete cleaning

In well-stocked supermarkets and drugstores,
you will find special dishwasher cleaning
products. Cleaning the appliance using these
products takes place when the dishwasher is
empty and is very intensive. You should clean
the dishwasher in this way from time to time.
When doing so, please note the manufactur-
er instructions on the packaging.
Protection against frost
damage
Position the dishwasher in an area which is
protected from frost, if possible. If this is not
possible, protect the dishwasher against frost
(29)
as follows. You will need a shallow dish or a
pan, and a sponge.
1. Disconnect the mains plug from the sock-
et or switch off the fuse.
2. Turn the tap off and unscrew the (24) inlet
hose.
3. Let the water from the inlet hose flow
completely into the dish.
4. Remove the filters (18).
5. Remove the water from the sump floor
with the help of a sponge.
Page EN-21