Part View; Level/Pan Tab; Keyboard Tab - Roland FA-06 Parameter Manual

PART VIEW

1.
Press the [MENU] button .
2.
Move the cursor to "Part View"
The PART VIEW screen appears .
Parameter

Level/Pan tab

Type (Tone Type)
Bank (Tone Bank)
Number (Tone Number)
Mute
Solo
Level
Pan
Sw (Rx Switch)
Ch (Rx Channel)

Keyboard tab

Kbd (Keyboard Switch)
Arp (Arpeggio Switch)
R .L (Keyboard Range Lower)
R .U (Keyboard Range Upper)
and press the [ENTER]
Value
SN-A,
SN-S,
SN-D,
PCMS,
PCMD
PRST,
USER,
GM2
001–
OFF, ON
OFF, ON
0–127
L64–63R
OFF, ON
1–16
OFF, ON
OFF, ON
C-–G9
C-–G9
button .
Explanation
Specifies the type of tone/drum kit assigned to each part .
SN-A: SuperNATURAL Acoustic Tones
SN-S: SuperNATURAL Synth Tones
SN-D: SuperNATURAL Drum Kits
PCMS: PCM Synth Tones
PCMD: PCM Drum Kits
Selects the group of the tone/drum kit assigned to each part .
* "GM2"
You can select if the tone type is PCMS or PCMD .
Selects the number of the tone/drum kit assigned to each part .
Specifies whether each part's performance is temporarily muted (ON) or not muted (OFF) .
*
The Mute parameter does not turn the part off; it mutes the sound by minimizing the volume .
Therefore, the part still receives MIDI messages .
Only the sound of the soloed part is heard .
Adjust the volume of each part .
This setting's main purpose is to adjust the volume balance between parts .
Adjust the pan of each part .
"L64" is far left, "0" is center, and "63R"
For each part, specify whether MIDI messages will be received (ON), or not (OFF) .
"OFF,"
If this is the part will not respond . Normally, you should leave this
"OFF" when you do not want a specific part to be playing during song playback .
Specifies the MIDI receive channel for each part .
Turns each part's keyboard switch on/off .
*
You can't change this setting if the Keyboard Mode is
Turns each part's arpeggio switch on/off .
*
You can't change this setting if the Keyboard Mode is
Specifies the lowest key of the keyboard range for each part .
*
You can't change this setting if the Keyboard Mode is
Specifies the highest key of the keyboard range for each part .
*
You can't change this setting if the Keyboard Mode is
NOTE
If you raise the lowest key above the highest key, or the highest key below the lowest key, the
other setting will change to the same value .
is far right .
"ON,"
"SINGLE," "SPLIT,"
or
"SINGLE."
"SINGLE," "SPLIT,"
or
"SINGLE," "SPLIT,"
or
Studio Set
but you can turn it
"DUAL."
"DUAL."
"DUAL."
9