Ring Modulator; Step Ring Modulator; Auto Pan - Roland FA-06 Parameter Manual

IFX Parameters

15: Ring Modulator

This is an effect that applies amplitude modulation (AM) to the
input signal, producing bell-like sounds . You can also change the
modulation frequency in response to changes in the volume of the
sound sent into the effect .
L in Ring Mod
R in
Ring Mod
Parameter Value
Frequency 0–127
Sens 0–127
Determines whether the frequency modulation moves
towards higher frequencies or lower frequencies .
Polarity
UP
DOWN
Low Gain -15–+15 dB
High Gain
-15–+15 dB
D100:0W–
Balance
D0:100W
Level 0–127

16: Step Ring Modulator

This is a ring modulator that uses a 16-step sequence to vary the
frequency at which modulation is applied .
L in Step Ring Mod
R in
Step Ring Mod
Parameter Value
Step 01-16 0–127
0 .05–10 .00 Hz,
Rate
note
Attack
0–127
Low Gain -15–+15 dB
High Gain
-15–+15 dB
D100:0W–
Balance
D0:100W
Level 0–127
74
2-Band EQ L out
R out
2-Band EQ
Explanation
Adjusts the frequency at which
modulation is applied .
Adjusts the amount of frequency
modulation applied .
Higher frequencies
Lower frequencies
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct
sound (D) and the effect sound (W)
Output level
2-Band EQ L out
R out
2-Band EQ
Explanation
Frequency of ring modulation at each
step
Rate at which the 16-step sequence
will cycle
Speed at which the modulation
frequency changes between steps
Amount of boost/cut for the
low-frequency range
Amount of boost/cut for the
high-frequency range
Volume balance of the original sound
(D) and effect sound (W)
Output volume
17: Tremolo
Cyclically modulates the volume to add tremolo effect to the sound .
L in
Tremolo
R in
Tremolo
Parameter Value
Modulation Wave
TRI
SQR
SIN
Mod Wave
SAW1/2
SAW1
0 .05–10 .00 Hz,
Rate
note
Depth
0–127
Low Gain
-15–+15 dB
High Gain
-15–+15 dB
Level 0–127

18: Auto Pan

Cyclically modulates the stereo location of the sound .
L in
Auto Pan
R in
Auto Pan
Parameter Value
Modulation Wave
TRI
SQR
SIN
SAW1/2
Mod Wave
SAW1
R
L
0 .05–10 .00 Hz,
Rate
note
Depth
0–127
Low Gain
-15–+15 dB
High Gain
-15–+15 dB
Level
0–127
2-Band EQ L out
R out
2-Band EQ
Explanation
Triangle wave
Square wave
Sine wave
Sawtooth wave
SAW2
Frequency of the change
Depth to which the effect is applied
Gain of the low range
Gain of the high range
Output Level
L out
2-Band EQ
R out
2-Band EQ
Explanation
Triangle wave
Square wave
Sine wave
Sawtooth wave
SAW2
R
L
Frequency of the change
Depth to which the effect is applied
Gain of the low range
Gain of the high range
Output Level