Studio Set; Studio Set Common; General Tab; Control Tab - Roland FA-06 Parameter Manual

Studio Set

STUDIO SET COMMON

1.
Press the [MENU] button .
2.
"Studio Set Common"
Move the cursor to
The STUDIO SET COMMON screen appears .
Parameter

General tab

Keyboard Mode
Pad Part Select
Drum Comp+EQ Assign

Control tab

Control Source Select (System)
Tone Control Src1–4

Phase Lock tab

Phase Lock (Ch1)–Phase Lock
(Ch16)
and press the
Value
This specifies the play mode .
SINGLE
SPLIT
DUAL
STUDIO SET
Part1–Part16, OFF
Part1–Part16
SYSTEM, STUDIO SET
OFF,
CC01–CC31,
CC33–CC95,
PICTH BEND, AFTERTOUCH
OFF, ON
[ENTER]
button .
Explanation
Single play
Split play
Dual play
Multi part play
Specifies the pad part (the part that records performance data from the pads) .
Specifies the part that will use the six sets of compressor + equalizer that are provided for use with
a drum kit .
*
If a tone (not a drum kit) is assigned to the part specified by Drum Comp+EQ Assign, the
Comp+EQ will not be available .
SYSTEM: The Control Source Select system parameters System Control 1–4 Source are used for
tone control .
STUDIO SET: Tone Control Src1–4 are used for tone control .
* Control Source Select (System) settings are system parameters .
* "SYSTEM,"
If you choose the settings of the studio set parameters Tone Control Src1–4 are
ignored .
Specify the MIDI messages that will be used for Tone Control of the studio set .
Set Phase Lock to "ON" when you want to suppress discrepancies in timing of parts played on the
same MIDI channel .
When the Phase Lock parameter is set to
a condition in which their timing is matched, enabling them to be played at the same time .
Accordingly, a certain amount of time may elapse between reception of the Note messages and
playing of the sounds . Turn this setting to
*
Phase Lock is not available for SuperNATURAL acoustic organ-type instruments .
"ON,"
parts on the same MIDI channel are put in
"ON"
only as needed .
5