Table of Contents
Advertisement
GTD-2000TxW
Instruction Manual
5.2. Main PCB Configuration
■ After detaching the display parts, the Main PCB terminal layout appears as shown in the figure below.
No
NAME
1
CN9
2
J1
3
CN1
4
CN8
5
CN6
6
D1
7
OC1,OC2,OC3
8
CN4
■ Using OC1, OC2, and OC3 shown in the layout above, HART option board can be attached and 3ØScrew holes
located at top left of HART option board are used for fixing.
[Figure 5. Main PCB Terminal Layout]
Power & Output Signal Terminal
4~20mA Source / Sink Selection Jumper ( ON: Source Type, OFF: Sink Type)
Display LCD Connector
Sensor Connector
Program download Connector
Status LED (Flashes in 1 sec interval during normal operation)
HART Option Board Connector
Warning light (GTL-100) Interface Connector
[Table 2. Main PCB Key Part Description]
5. Installation
DESCRIPTION
Advertisement
Table of Contents
