Installing The Hardware; Installing The Mvme187 In The Chassis - Motorola MVME187 Installation Manual

Hardware Preparation and Installation

Installing the Hardware

3

Installing the MVME187 in the Chassis

Step
Remove IACK and BG jumpers from backplane
1
MVME187 is to be installed in.
2 Carefully slide the MVME187 into the card slot in the front of the chassis.
3-16
This section covers
Installation of the MVME187 into a VME chassis
Overview and installation of transition modules and adapter
boards
Connection of peripheral equipment such as console
terminals, optional SCSI drives, and serial or parallel printers
Note that if the MVME187 is to be used as system controller, it must
installed in the left-most card slot (slot 1), otherwise it may be installed in
any unused double-height card slot.
Table 3-9. MVME187 Installation Procedure
The MVME187 requires power from both P1 and P2. Be sure the
module is seated properly into the P1 and P2 connectors on the
backplane.
Do not damage or bend connector pins.
Fasten the MVME187 in the chassis with screws provided,
making good contact with the transverse mounting rails to
minimize RFI emissions.
Action
for the card slot that the