Table of Contents
Advertisement
21
Holding the module by the injector/ejector handle, slide it into an available
5.
PXIe (or hybrid) slot, as shown in the following figure.
Install the module into the slot of the chassis by placing the module
a.
card edges into the front module guides (top and bottom).
Slide the module to the rear of the chassis and ensure that the injector
b.
/ejector handle is pushed down in the unlatched (downward) position.
Slide the module completely into the chassis. When you begin to feel
c.
resistance, pull up on the injector/ejector handle to fully inject the
module into the chassis.
Secure the module to the chassis using the module mounting screws. Use a
6.
®
#1 Pozidriv or a slotted screwdriver and torque to 5 Lb-In (0.57 N-m).
Performance may suffer if the screws are not tightened properly.
Verify that the PXIe chassis fans are operable and free of dust and other
7.
contaminants that may restrict airflow.
Install filler panels and slot blockers after installing the module. Missing filler
8.
panels or slot blockers may disrupt air circulation in the chassis. The left-
most slot does not accept a slot blocker.
If you are using a PCIe Cable Interface, such as the Keysight M9021, connect
9.
the Cable Interface in the chassis to the PC host per the instructions that
came with the Cable Interface.
Power up the PXIe chassis.
10.
If you are using a remote PC, reboot the PC host.
11.
Proceed to
Step 5 - Verify Operation of M9451A Module
12.
Keysight M9451A PXIe Measurement Accelerator
.
Advertisement
Table of Contents
