Server Attached Storage; Installing A Jbod Unit - Avaya Media Processing Server 500 Hardware Installation And Maintenance

Installing Hardware and Configuring Connectivity
Figure 23: Rear Panel Connectors

Server Attached Storage

Currently the server is equipped with one (two optional) Ultra160/360 SCSI drives. The server is
equipped with a RAID 1 card, but installing the optional second hard drive provides maximum fault
protection.

Installing a JBOD Unit

Refer to the online documentation for the SANnet II Blade JBOD unit at:
http://www.dothill.com/index.asp
The JBOD unit requires one of the following power sources. Check your SDP for the type of power
required for your installation.
Table 1: JOBD Power Requirements
Type Voltage
AC 100-240VAC at 50/60 Hz, single-
phase
DC -48VDC or -60VDC
Avaya Media Processing Server 500 Hardware Installation and Maintenance
48
Current
4A maximum per input
8A maximum per input
Comments? infodev@avaya.com
Power
100W typical
100W typical
October 2014