Table of Contents
Advertisement
Installing the drive
1. Having configured the drive, turn the drive bay
upside-down and rest it on a flat surface with the
front of the floppy drive towards you.
2. Slide the hard disk drive you are installing into the
bay from the front, with the drive circuit board up,
and its connectors away from you.
Warning
If there is a drive in the bay already, be careful to
ensure that the new drive does not touch it.
Warning
It is possible to damage hard disk drives when
attaching them using side mounting holes. When
installing Apricot supplied hard disk drives make
sure that you use the screws supplied with the
drive, and that all washers supplied are used.
When installing drives supplied by third parties, be
careful to ensure that securing screws do not come
into contact with drive circuit boards. If in doubt
check with your supplier.
3. Line up the screw holes on the sides of the drive
with those in the bay, insert the securing screws
supplied with the drive and tighten them until they
are finger tight.
51
Advertisement
Table of Contents
