5. Remove the two screws that secure the 5.25" drive
bay and slide the bay backwards.
6. Lift the 5.25" bay out of the system unit and put it
down on a safe flat surface.
7. Disconnect the cable from the rear of the 3.5" floppy
drive.
8. If a 3.5" hard disk is fitted remove the signal and
power cables from the rear of the drive.
9. The 3.5" drive bay is secured by two screws and
two lugs in the system unit base. Identify the screws
and lugs from the following illustration.
10. Remove the two securing screws shown in the
illustration above.
11. Slide the 3.5" drive bay backwards and lift it out of
the system unit.
int l e
DX
TM
i
486
SECURING
SCREWS
49