Table of Contents
Advertisement
Drive configuration
The XEN-LS II 3.5" drive bay supports two 1" high hard
disk drives. In order for the drive or drives to operate they
must be correctly configured.
The IDE interface supports a maximum of two drives.
These drives are known as Master and Slave. A single
drive, or the boot device in a dual drive system, must be
configured as Master. The second, non-bootable, drive in a
dual drive system must be configured as Slave.
IDE drives are normally configured using jumpers on the
drive. Configuration details may vary from drive to drive.
Apricot drives are supplied with documentation describing
how to configure the drive.
If you are uncertain about configuring the drive check with
your supplier.
50
Advertisement
Table of Contents
